RAEX MP46 – motore Wi-Fi per binari da tenda
Motore per binari da tenda: apre e chiude le tende da app, a orario o su scenario, con comando Wi-Fi.
- Apertura e chiusura motorizzata delle tende su binario
- Comando da app, a orario o su scenario
- Funzionamento silenzioso, adatto a camere e soggiorni
- Da abbinare al binario RAEX della misura giusta
| Parameter: | Value |
| Model: | MP46WIFI |
| Rated voltage: | 100 – 240 VAC |
| Rated frequency: | 50/60 Hz |
| Rated torque: | 1.0 Nm |
| Rated speed: | 110 rpm (75/90 adjustable speed) |
| IP grade: | IP41 |
| Insulation grade: | E |
| Operating temperature: | 0 to +50°C |
| Storage temperature: | -20 to +70°C |
| Control connector: | RJ9 |
| Control method: | Dry contact |
| Voltage in control line: | 5 VDC |
| Net weight: | 597 g |
| Size (H x L x W): | 39.4 x 320 x 39.4 mm |
| Wi-Fi | |
| Protocol: | 802.11 b/g/n |
| RF band: | 2412 – 2484 MHz |
| Max. RF power: | < 20 dBm |
| Range: | Up to 30 m / 100 ft indoors and 50 m / 160 ft outdoors (Depends on local conditions) |
| Bluetooth | |
| Protocol: | 5 |
| RF band: | 2402 – 2480 MHz |
| Range: | Up to 10 m / 33 ft indoors and 30 m / 100 ft outdoors (Depends on local conditions) |
| Parameter: | Value |
| Length: | 2.3 to 4.0 m |
| Maximum curtain weight: | 30 kg |
| Operating environment: | Indoor use only |
| Problem: | Possible cause Solution |
| The motor does not respond: | Power supply issue Check that the AC power connection is secure and power is available. |
| The curtain does not close completely: | The curtain moves in the opposite direction Use the remote control to send “Reverse” command to correct the direction. |
| The curtain does not close completely: | Limits data error Turn off the system for 60 seconds. |
| The external control button does not work: | Poor connection of the signal cable Ensure the signal cable is firmly connected and is not damaged. |
| The remote control does not work: | The remote is not paired Re-pair the remote with the curtain motor. |
| The remote control does not work: | The remote’s battery is low Replace the battery with a new one. |
| The remote control does not work: | The distance is too long Move closer to the receiver. |
| The curtain stops before reaching the limit: | Limit is not properly set Recalibrate the motor. |
| The curtain stops before reaching the limit: | The curtain is heavy Refer to these instructions or your curtain track’s user manual to ensure the curtain weight is within the specified limits. |
| The curtain stops before reaching the limit: | Curtain is blocked by an obstacle Check the track and the accessories for obstructions. |
| Other: | — Turn off the system and wait for 1 minute before turning it back on. If the problem persists, contact your dealer for assistance. |
